Metamask: I am having uniswap problems [duplicate]

UNISWAP problems with Metamk and Ledger: a problem solving guide

As a frequent UNISWAP user, a popular decentralized exchange platform (DEX) built in Ethereum, is not just in experiencing problems with the protocol. One of the most frustrating problems that users find is when they try to exchange tokens using their metamash wallet or Ledger hardware wallet with the UNISWAP interface.

In this article, we will deepen the causes of these problems and provide a step -by -step guide on how to solve and solve them.

Falling gas estimation error «

When you try to exchange tokens in Uniswap using MetamSk or Ledger, you can receive an error message that indicates that gas estimation failed. This error occurs when the estimated gas limit of your account is too low for the transaction, which makes the Ethereum block chain reject it.

Causes of error of «Falling Gas Estimation»

Several factors can contribute to this problem:

• Incorrect gas limits : If you establish the gas limit of your account too high or have not recently updated, the gas estimation could fail.

• Unlocked wallets

  

  : The use of a wallet with sufficient funds and unlocked configurations (for example, hardware wallets of the biggest book) can cause gas estimation errors.

• Excessive transactions : Make multiple transactions in a rapid succession can increase gas estimation, which leads to rejection.

Problem solution steps

To solve these problems, follow these steps:

Step 1: Update your metamask wallet and ledger

• Be sure to run the latest version of MetamSk and Ledger firmware.

• Go to the configuration of your wallet and update the account configuration to reflect your current balance and gas limit.

Step 2: Establish the correct gas limits

• Check your estimated gas limits on UNISWAP and adjust them according to the available funds.

• Consider using a separate gas limit wallet (for example, MetamSk) for sensitive transactions.

Step 3: Optimize your transactions

• Make multiple transactions in rapid succession to increase gas estimation.

• Avoid performing excessive transactions; This will help minimize gas estimation errors.

Step 4: Use a ledger wallet with reduced gas limits

If you are using a Ledger wallet, consider reducing the gas limit for the configuration of your account:

• Go to the firmware configuration of the biggest book and reduce the gas limit for your account.

• Verify that your account is still working within reduced gas limits.

Step 5: enable gas estimation

• In Metamask, go to configuration> Wallet settings> Advanced Settings

• Alternate in «Gas Estimation» (available in some versions of MetamSk)

Following these steps and taking the necessary precautions, you must be able to solve the error of «failed gas estimation» by exchanging tokens in UNISWAP using your metamask or Ledger wallet.

Conclusion

Uniswap’s problems with Metamask and Ledger can be frustrating, but by understanding the causes of these problems and implementing the recommended problem solution steps, they should be able to solve them. Remember to keep up with the latest software versions, adjust your gas limits as necessary, optimize your transactions, use a reduced gas limit, enable Gas estimation in MetamSk and monitor the performance of your close account.

Happy trade!

EXPLORING SAFE WITHDRAWALS